Got a Ford 8.8 with 4.88s front and rear installed in my yj. What a difference from the stock 4.11s! Any way after installing we found my springs had a 6* shim (should have noticed on removal but didn’t) so I figured I would just do a SYE and double cardan DS. Anyone have any pointers? It’s the Advanced adapters SYE and I’ll be using a Bills Englewood driveshaft. From the instructions it says to press out the needle bearings from the main drive gear since it’s a pre 97, is there any way I can do that without bringing it to someone with a press? Or is there anyone in the Lakewood area that would let me use theirs? I’ll have this weekend to figure it out and get it finished as it’s my daily driver.
thanks in advance