58 Willys Wagon

[FINOCJ]

No...parts are fine, just user error with the press. Learning as I go, and trying not to screw stuff up too bad. Hopefully mainshaft assembly will start to go quicker...but then getting the jumble of countershaft, mainshaft and input shaft all back into the case properly with bearings will probably be a PITA....

[FINOCJ]

A bit of progress...all bushings and synchro hubs pressed on etc...one side of mainshaft complete.... doesn't seem like a lot, but I am slow and only get a couple hours every so often.

[Jim]

FINOCJ previously posted:

[FINOCJ]

Yup....in the middle of a 14 day straight work stretch. My place is nicely located within walking distance to work, but no garage or workshop (just a condo), so I have to travel an hour to town (west yellowstone) to a friends house with garage etc. Was trying to come down once a week on my day off, but sometimes it just doesn't happen.