3rd gen Taco

[cnstaco]

Still getting it dialed in.

[RockyMtRebel]

Chris, let’s get the trucks out this summer!

[speedkills]

Looking sharp!

[jayson44]

nice! 37s?

J.

[cnstaco]

I’m back and the build is mostly completed. Front camburg +2 LT with an LC 200 rack 10 of travel with chromoly shafts from cvj. Rear deavers with 14 bilstien and hammer hangers 12.5 of travel stock axle. 5.29s fully locked. Front case Rf1a 4.7 TG with some Marlin mixed in, rear is a stock 2.57 electronic shift. I’m running TR beadlocks with 37 stt pros. Final crawl in lolo is around 230:1. Lots of other stuff!

[cnstaco]

Here’s my latest Camburg steering knuckle mock up. I used scrap construction steel and ordered a piece of 1/4 wall 1 5/16 Dom for the tie rod. Not going to weld it until I verify the geometry is good.

[Getaklu]

Nice!

[cnstaco]

Well I still have toe in at full bump. So I’m going to move the heim location on the knuckle down. Camber is at 0 at ride height along with toe. Caster is locked at 3*. I’m showing a camber change of 2-3* through out the cycle. Getting closer

[cnstaco]

So close to finish weld. Bump steer is 0 until 5” droop 1/16th in. I’m bumped at 4” up and 5” down. So 9” of travel I can remove the spacer and get 2” more of up travel but will have to cut a lot of inner fender. Also the rear is bumped at 4.5” up and 8” down. Some day I hope to get them equal. It never ends

[Jim]

That looks great!

[cnstaco]

Total chaos

[Mountaineer01]

cnstaco previously posted:

[Tom]

Mountaineer01 previously posted:

[cnstaco]

All done.

[Getaklu]

Nice Chris!

[cnstaco]

Thanks man! We definitely need to go wheeling this season!