scout man previously posted:
"Oh man, that one is some work there. That would be pricy. If you wanted to go with sharper angles it would be a different story, but with those kinds of curves and gradual angles that's a lot of work!"
I agree to a point. Figuring out the correct radius needed for each section would be the tough part. As long as one had the big enough plate roller. Honestly would probably take about the same time as sharper angles once all was said and done. Might save a couple hours but not much.
If you wanted a ballpark quote from me, I would range it at 40-60 hours of labor plus materials and coating of your choice.
Hope that this helps.