Search:

Got trailer out and in use over the weekend. Learned it is better to have the tent opening downhill on a slope to keep max height in the annex. Overall worked great and stayed a bit warmer than old...

I wonder if a fabricator could make you a new spindle. I know Aaron is amazing with metal and makes his own tooling for some things.

welcome

Got the trailer back today and opened up the tent to start getting the bedding in just see how set up goes. Did it on the concrete so we didn't get the annex fully stretched out to full size but it...

The tent has an annex room so the bottom of tent needs to be at 72" off the ground. During transport I didn't want the tent setting up higher than the Jeep so it lowers for transport and then gets...

welcome to the group. Had a blast climbing in the black hills last summer and looking forward to getting back.

He extended the drop leg for the new height on trailer. Framed reinforcement for the top and installed locking latches. Again pictures are out of order.

Finally got the trailer to Brucker Brothers for him to do his magic. Trailer is going to be in use this year!
He framed up the top and repaired tongue that was bent. Put hinges on top for lid to...

How are you coming up with an increase of 480 rpm? going 4.88 is an increase of 440 rpm versus the 4.1 on the 35" tire but what you want to do is maintain close to factory ratio. 4.1 gear on stock...

welcome to the group

welcome to the group

welcome to the group

I have Bill's shafts on both my Jeeps but have had them quite a while so can't remember what I paid. They do not install them. You measure the length and they build it for you. He used to give a...

welcome to the group

welcome to the group

Jeeps lookin good. the shocks should not be what stops the drop of axle or you will be ripping apart shocks. Get a set of limiting straps and set it so they stop the axle droop where you want it. ...

welcome to the group

looking sharp all cleaned up

Had to say our goodbyes to Max yesterday. He had cancer and it had spread before we even knew about it.

Spent a week in South Dakota camping at Sheridan Lake. Got a few days of climbing in and had some time left over for a little site seeing. Even met one of the authors of my climbing guidebook due...

Spring creek the first obstacle can be bypassed completely, there is also a bypass that has gotten pretty torn up. Very possible to roll the front up and over on the wall, far right is best line. ...

Glad you found someone to get er done. tire irons have an edge to them that can rip the tire, in a pinch they work but not recommended. I have a set of spoons and a manual style bead breaker (I...

the age of the old unit, it would have been r22 which is no longer made or units that use it. It can be found but it is all recycled. Typical rates for r22 is $30-50 per pound(customer cost). It...

I just went through the process of setting up an album as I have not done that in quite a while. There is a drop down setting for category while setting up album. There are 5 choices. ...