PDA

View Full Version : 96-04 First Gen Tacoma high clearance rear bumper



trailfiend
April 28th, 2014, 10:09 PM
SOLD!! Thanks for looking :)



https://lh3.googleusercontent.com/-dy9qVShpP7M/U18eDm3hw2I/AAAAAAAAa84/X7IDiCl7yeo/s640/wm-LQ-0140.jpg


https://lh4.googleusercontent.com/-muGWm7jzybE/U18eDynVSGI/AAAAAAAAa9E/SRxBBvPz43g/s640/wm-LQ-0143.jpg


https://lh5.googleusercontent.com/-BewKnDbFX3c/U18eEcpgJpI/AAAAAAAAa9A/H2cx1gsGt9U/s640/wm-LQ-0145.jpg


https://lh5.googleusercontent.com/-GmM7rA05Iug/U18eE6NicsI/AAAAAAAAa9M/y1dkCle1_SQ/s640/wm-LQ-0148.jpg


https://lh6.googleusercontent.com/-aZnJ6rbYBGU/U18eFI7eqMI/AAAAAAAAa9Y/57hVo9FhXXM/s640/wm-LQ-0149.jpg


https://lh6.googleusercontent.com/-3tCOKV_SOyw/U18eFPpCGFI/AAAAAAAAa9U/nzVwEzsZmm4/s640/wm-LQ-0152.jpg

Geno
April 29th, 2014, 02:03 AM
I like the looks , but , not wild about trimming off my fender corners. Been looking for a new rear bumper for my 01 Taco. Any pictures of the mounting setup, I still carry my 285/75/16 under my bed.

Rick
April 29th, 2014, 07:03 AM
looks great Alex...whats wrong with keeping what you have there? Just curious

trailfiend
April 29th, 2014, 07:30 AM
Geno,
I can understand the desire not to cut your sheetmetal, I did a bit of trimming on my XJ when I had it, trimmed the LQP as well, so I had already adjusted myself to the concept (and I figure if I REALLY screw up, I'll just go to the scrap yard and buy a bed). But here's the mounting plate, the forward-most hole is the one I added.

https://lh3.googleusercontent.com/-MV2cyw0RZfk/U1-ljtSFdFI/AAAAAAAAa9o/Cf2x71WcpIo/s640/KIMG0069.JPG

https://lh4.googleusercontent.com/-GYcXaNWex9E/U1-onmx-WTI/AAAAAAAAa90/zqN7vWnUGfU/s640/KIMG0070.JPG

https://lh3.googleusercontent.com/-lHef9YpyTCQ/U1-or_mo8QI/AAAAAAAAa98/02Smjv8FJ3g/s640/KIMG0092.JPG

And here's kind of the overall profile
https://lh4.googleusercontent.com/-y0xhVx1aX2s/U1-ow9EJ9nI/AAAAAAAAa-E/SFx81T0sSdE/s640/KIMG0093.JPG

Rick,
I want to tweak the design slightly is all :) Like the bevel plating on this for the center is 4" flat, I might get 5" flat to make the angles on the side more pronounced, I can refine the corners a little more, and I'll be doing a tire carrier