View Full Version : FS tubing bender
Brad
February 24th, 2014, 08:09 AM
I am posting this for Jeff at JC's British
This is our old manual tubing bender. It only has a 1.75" die $175, PM me or post any questions you may have.
foxtrot
February 24th, 2014, 09:44 AM
How well does it work? Is it basically the same as the harbor freight style?
Brad
February 24th, 2014, 10:08 AM
I would think it is better than the harbor freight. They go for $399.99 new.
http://www.eastwood.com/professional-tubing-bender.html
foxtrot
February 24th, 2014, 11:21 AM
Can it do 90 degrees on 1.75? Website only shows 60
Brad
February 24th, 2014, 12:59 PM
I would guess the website is accurate. I will check and get back to you.
Brucker
February 24th, 2014, 02:03 PM
If the photos are correct, that bender is actually from Williams Low Buck Tools: http://www.lowbucktools.com/hydbender.html
It is a true mandrel tubing bender, not a pipe bender like the HF one mentioned. It should not kink or distort the tubing.
FYI- Looks like the top mount for the jack is bent. Probably from trying to bend something a little too thick. It would probably be ok, but something to watch if it is indeed bent.
Brad
February 24th, 2014, 05:31 PM
Sale pending.
Front Range 4x4 forums are powered by vBulletin™ Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.