Front Range 4x4 Upcoming Trail Runs - Add a New Trail Run

Results 1 to 11 of 11

Thread: I would like to get out

  1. #1
    Join Date
    Mar 2012
    Member
    #1028
    Last Online
    3 Hours Ago
    Location
    Longmont
    Age
    72
    4x4
    '12 Jeep Wrangler Sport 2.5" lift, 33s, winch
    Posts
    5,085
    User Name
    Tom
    Real Name
    Tom
    Thanks Given
    2,431
    Thanked 1,238 Times in 937 Posts

    Default I would like to get out



    Thinking something easy and close and quick. Perhaps Switzerland trail one day next weekend (25th or 26th) Health issues are limiting me.

    If no interest I will likely go solo. If interest I will post it up.
    ___________
    Tom
    -.- . ----- .-- - -.-.

  2. #2
    Join Date
    Sep 2011
    Member
    #921
    Last Online
    1 Hour Ago
    Location
    Fort Collins
    4x4
    1990 Jeep Wrangler (YJ)
    Posts
    10,106
    User Name
    Jim
    Real Name
    Jim Williamson
    Thanks Given
    2,496
    Thanked 3,036 Times in 2,018 Posts

    Default Re: I would like to get out



    If my jeep's back, I could (though odds are essentially zero)...

    `shop gave me some undesirable news this week. It went in for rear pinion seal replacement (done, only a very small groove on the pinion surface - their recommendation is to run it as-is vs sleeve it or replace it). The issues come in with the front axle - it was in for passenger side seals replacement. When they went to uninstall they found VERY loose bearings - that caused damage.

    The spindles, aftermarket Ford Ranger with locking hubs, have two lock nuts to keep the taper bearings tight - those locknuts have a locking ring between them. The ring has a tang that fits into a groove on the threaded spindle. The tang rotated into the threaded area and damaged some threads. Loose bearings (ie VERY loose) caused damage to several surfaces - inner bearing's outer race to knuckle (race was spinning a bit), the brake pad backing plate slides on - on the knuckle, the brake caliper, outer area for the caliper pins.

    The maintenance finger wholly points at me lacking maintenance on the system. The nut tightening has been an issue. I replaced the nuts and lock ring and researched proper tightening. I have the socket for the outer nut but not a wrench to hold the inner nut. This inner wrench will now be purchased for me to tighten the system with assurance. I'll want to check for slop more frequently. Ugh. This is notice that I need to give the jeep proper attention.

    I asked the shop to tend the "inside the axle" items and I'll tend the outside the axle items. They'll complete their work and I'll drive it home (likely some time next week) and pull it into the garage for proper work.

  3. The Following Member Says Thanks to Jim For This Post:

    Tom (November 18th, 2023)

  4. #3
    Join Date
    Jan 2022
    Member
    #2917
    Last Online
    8 Hours Ago
    Location
    Severance, CO
    4x4
    2022 JLUR
    Posts
    198
    User Name
    hiimmike
    Real Name
    Mike
    Thanks Given
    61
    Thanked 55 Times in 44 Posts

    Default Re: I would like to get out



    Hey Tom - I am good for the 25th, are we thinking this is a snow wheeling day?

    Jim - If you want to ride along or or drive (I know you love that JL refinement ) let me know. I apparently have a small roll of your trash bags from The Maze to get back to you.

  5. The Following Member Says Thanks to hiimmike For This Post:

    Jim (November 19th, 2023)

  6. #4
    Join Date
    Feb 2010
    Member
    #595
    Last Online
    6 Days Ago
    Location
    Evergreen, Co
    4x4
    2008 Jeep Rubicon
    Posts
    4,828
    User Name
    Jackie
    Real Name
    Jackie
    Thanks Given
    656
    Thanked 520 Times in 386 Posts

    Default Re: I would like to get out



    I'm out for the year, Tom. I hope my Jeep lasts through the winter as my DD without major work. (Plus, I hate winter)! I hope get to feeling better soon. Happy Holidays!

  7. #5
    Join Date
    Mar 2012
    Member
    #1028
    Last Online
    3 Hours Ago
    Location
    Longmont
    Age
    72
    4x4
    '12 Jeep Wrangler Sport 2.5" lift, 33s, winch
    Posts
    5,085
    User Name
    Tom
    Real Name
    Tom
    Thanks Given
    2,431
    Thanked 1,238 Times in 937 Posts

    Default Re: I would like to get out



    hiimmike previously posted:
    "Hey Tom - I am good for the 25th, are we thinking this is a snow wheeling day?

    Jim - If you want to ride along or or drive (I know you love that JL refinement ) let me know. I apparently have a small roll of your trash bags from The Maze to get back to you."

    I am hoping for very little snow. If it dumps I likely won’t do it.
    ___________
    Tom
    -.- . ----- .-- - -.-.

  8. #6
    Join Date
    Sep 2011
    Member
    #921
    Last Online
    1 Hour Ago
    Location
    Fort Collins
    4x4
    1990 Jeep Wrangler (YJ)
    Posts
    10,106
    User Name
    Jim
    Real Name
    Jim Williamson
    Thanks Given
    2,496
    Thanked 3,036 Times in 2,018 Posts

    Default Re: I would like to get out



    hiimmike previously posted:
    "Jim - If you want to ride along or or drive (I know you love that JL refinement ) let me know. I apparently have a small roll of your trash bags from The Maze to get back to you."

    That'd be fun - you bet. Let's see how things go.

    As for the bags - if you can use them - keep'm otherwise if you wish to get them off your hands and it works out - sure thing.

  9. #7
    Join Date
    Mar 2012
    Member
    #1028
    Last Online
    3 Hours Ago
    Location
    Longmont
    Age
    72
    4x4
    '12 Jeep Wrangler Sport 2.5" lift, 33s, winch
    Posts
    5,085
    User Name
    Tom
    Real Name
    Tom
    Thanks Given
    2,431
    Thanked 1,238 Times in 937 Posts

    Default Re: I would like to get out



    Well of course,
    CBS weather, “cooler weather arrives on Thanksgiving. Then much colder weather and a chance for snow arrives on Friday.”
    ___________
    Tom
    -.- . ----- .-- - -.-.

  10. #8
    Join Date
    Sep 2011
    Member
    #921
    Last Online
    1 Hour Ago
    Location
    Fort Collins
    4x4
    1990 Jeep Wrangler (YJ)
    Posts
    10,106
    User Name
    Jim
    Real Name
    Jim Williamson
    Thanks Given
    2,496
    Thanked 3,036 Times in 2,018 Posts

    Default Re: I would like to get out



    Tom previously posted:
    "and a chance for snow"

    You can use my snow chains and break trail !!

  11. #9
    Join Date
    Mar 2012
    Member
    #1028
    Last Online
    3 Hours Ago
    Location
    Longmont
    Age
    72
    4x4
    '12 Jeep Wrangler Sport 2.5" lift, 33s, winch
    Posts
    5,085
    User Name
    Tom
    Real Name
    Tom
    Thanks Given
    2,431
    Thanked 1,238 Times in 937 Posts

    Default Re: I would like to get out



    Jim previously posted:
    "You can use my snow chains and break trail !!"

    Not phyically up to that much work Jim. A few years ago sure. Not now.
    I am down 40 lbs this year due to health.
    ___________
    Tom
    -.- . ----- .-- - -.-.

  12. The Following Member Says Thanks to Tom For This Post:

    Jim (November 20th, 2023)

  13. #10
    Join Date
    Mar 2012
    Member
    #1028
    Last Online
    3 Hours Ago
    Location
    Longmont
    Age
    72
    4x4
    '12 Jeep Wrangler Sport 2.5" lift, 33s, winch
    Posts
    5,085
    User Name
    Tom
    Real Name
    Tom
    Thanks Given
    2,431
    Thanked 1,238 Times in 937 Posts

    Default Re: I would like to get out



    Based upon the updated forecast I am not going to get out this weekend.
    ___________
    Tom
    -.- . ----- .-- - -.-.

  14. The Following Member Says Thanks to Tom For This Post:

    Jim (November 22nd, 2023)

  15. #11
    Join Date
    Jan 2022
    Member
    #2917
    Last Online
    8 Hours Ago
    Location
    Severance, CO
    4x4
    2022 JLUR
    Posts
    198
    User Name
    hiimmike
    Real Name
    Mike
    Thanks Given
    61
    Thanked 55 Times in 44 Posts

    Default Re: I would like to get out



    On the plus side…. I got… “babies first snowblower.”




  16. The Following Member Says Thanks to hiimmike For This Post:

    Jim (November 26th, 2023)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
BACK TO TOP