New driveshaft(s)
Rolling around under the JKU today, found it is time for at least a front driveshaft, which I should have replaced when I did the lift. Looking mainly at Tom Woods and Adams. Any opinions based on experience? Thinking the 1310 will be fine, any reason to go with 1350?
Also, how feasible is it to mess up the crush sleeve in the diff if I over tighten the nut while putting on the new adapter? Not too worried about messing up the T and Tcase ends, just the diffs.
___________
"A wise and frugal government...shall restrain men from injuring one another, shall leave them otherwise free to regulate their own pursuits of industry and improvement, and shall not take from the mouth of labor the bread it has earned. This is the sum of good government." Thomas Jefferson