So I am trying to install the Iron Rock Off-road New double cardan C.V. driveshaft (top picture) I currently have the drive shaft that is stock and looks like the picture labeled 12 and 1 in the bottom picture. ( This kit comes with everything you need to convert your ball in socket Saginaw front driveshaft to a U-joint style C.V. driveshaft. Although not very strong, the factory Saginaw driveshaft works fine up to a lift height of about 4". Beyond 4" of lift this driveshaft may not be able to tolerate the angle created by suspension droop. This will cause accelerated driveshaft wear. - See more at: http://www.ironrockoffroad.com/10374....j1SWtRGs.dpuf)
Kit includes:
- New double cardan C.V. driveshaft (custom lengths available)
- Transfer case yoke (you will need to re-use your dust shield)
- Dana 30 Pinion yoke with U- bolt kit for fastening driveshaft to transfer case yoke
Once I get the stock drive shaft off i don't know to proceed.
Any help would be appreciated.
- See more at: http://www.ironrockoffroad.com/10374...h.j1SWtRGs.dpu