Jeep leak

[Java]

so here's a pic of where I park, it's a Jeep 4.0 with 60,180 miles on it. I'm guessing no one needs more than that to know I have a rear main seal leak. It showed up right after I switched to synthetic oil, and it's on my winter fix list. Does anyone know of an upgrade to the rear main? Any tips or anything before I dig in? I've done this seal before on my old 88 YJ's 258, it wasn't too hard except that I screwed up 2 of the top sides before getting one in correctly, so I ended up buying 3 seals overall. Any tips for getting the top 1/2 in easily? Thanks!!

[alexb]

Take good notes so that when I develop the same problem I can come over and have help with my seals.

[alexb]

If you want an extra pair of hands, let me know when and I'll see if I can make it there to learn what I can look forward to.

[Patrolman]

They actually make seal drivers that may help in seating the seal evenly. Unsure if that will help. I have this one at home:
http://www.harborfreight.com/10-piec...set-95853.html

[Brad]

I always recommend a seal driver.

[The StRanger]

Brad previously posted:

[carpenle]

Is it a 2 piece rear main? My xj is a 2 piece and is pretty easy.

[Java]

carpenle previously posted:

[Hypoid]

Yup, you want a brass drift to push the upper half through. Penetrating oil (PBlaster) will help.

[Dutch]

Those seal drivers won't do any good as its a 2 piece seal. Just lube up the upper seal with oil or assembly lube and be gently with it. Make sure to leave it slightly offset from the bearing cap seating surface. If you want to come up to Firestone I can help you out. I've got all the tools and a heated garage.

[Popsgarage]

And you might as well do a pan gasket while you're in there. It's cheap insurance. There are a million you-tube video how to's. Just be careful not to scratch the crank or seal surface of the block when you use the punch to drive it up and out. Which is why Mike said to use a brass drift to remove it.
Rear main seal and oil pan gasket by Felpro.

[Java]

got my universal bearing press / seal driver ready to go!

[Popsgarage]

Follow the directions on the main seal instructions. The lip of the seal goes a certain direction (which I can't remember right now) and use good quality parts like Felpro.

[Java]

for sure, Jon, cheap parts are their own reward. I found a few great write ups on it, and this one http://www.dailydriventj.com/forum/viewtopic.php?t=811 shows the Felpro solution to the problem I had with the upper half of the seal. Glad it's not just me! I'm still nowhere near actually doing this, my goal is to get it done before spring Moab. Just lining up the ducks...

[Popsgarage]

Paul previously posted: