Search:

Type: Posts; User: Brian

Page 1 of 2 1 2

Search: Search took 0.03 seconds.

  1. Thread: Exhaust 4.0 jeep

    by Brian
    Replies
    3
    Views
    73

    Re: Exhaust 4.0 jeep

    I went with this muffler because I didn't want it to be loud and it was a direct bolt on. It ran slightly shorter than stock, but I needed to run my tailpipe up higher anyway so I did both at the...
  2. Replies
    57
    Views
    705

    Re: Front upper control arms on 2005 LJ

    I have lower adjustable control arms on the front and I've adjusted them without jacking or tire removal. Just do one at a time and the other side should hold the axle in place. Maybe remove the...
  3. Thread: The Campfire.

    by Brian
    Replies
    3,093
    Views
    198,812

    Re: The Campfire.

    You should go buy a lotto ticket Jim!
  4. Replies
    32
    Views
    485

    Re: SBC ignition problem

    Can you swap out/in your CJ coil to test this?
  5. Replies
    3
    Views
    204

    Re: Matt's Towing & Recovery

    Dream Job!
  6. Thread: Hello everyone!

    by Brian
    Replies
    5
    Views
    242

    Re: Hello everyone!

    Welcome!
  7. Thread: The Campfire.

    by Brian
    Replies
    3,093
    Views
    198,812

    Re: The Campfire.

    IH could be a source for the bolt pattern and large hub opening.
  8. Replies
    13
    Views
    273

    Re: Nankang tires...?

    It's a UTV tire, but it does say DOT approved...hmmmmm.
  9. Replies
    13
    Views
    273

    Re: Nankang tires...?

    https://www.milestartires.com/tire-search-result/?size=33125015&genericSize=33X12.50R15

    I used the size button to find it.
  10. Replies
    13
    Views
    273

    Re: Nankang tires...?

    One of the guys in my club down here switched to Patagonia M/T's. I've seen them in action and they are impressive, and will be a consideration for my next set. They are made in a variety of AT and...
  11. Thread: 58 Willys Wagon

    by Brian
    Replies
    47
    Views
    1,894

    Re: 58 Willys Wagon

    I would recommend double checking the pan mating surface for any deformities that may have occurred while knocking out the dent. Try sitting it on the flattest table you have and try to rock it or...
  12. Thread: 58 Willys Wagon

    by Brian
    Replies
    47
    Views
    1,894

    Re: 58 Willys Wagon

    IMO, those blue Fel-Pro gaskets for the valve covers and oil pans are the shiznit, with no sealant required.

    :2c:
  13. Replies
    30
    Views
    1,073

    Re: Adopt a Road Sept Clean-Up

    Great idea, it's just every day of their visit is already accounted for. Obviously everyone wants to maximize the short amount of time they have together and that time just didn't allow a side trip...
  14. Replies
    30
    Views
    1,073

    Re: Adopt a Road Sept Clean-Up

    We have visitors coming. They are the overseas type so I gotta be there for it. Maybe next year I can get on the amoxicillin cycle and be asked to leave!
  15. Thread: Gear swap shop

    by Brian
    Replies
    5
    Views
    456

    Re: Gear swap shop

    Yeah, Tanner is still around but I haven't dealt with them personally. However, I'm sure they could install gears no problem as well.
  16. Thread: Gear swap shop

    by Brian
    Replies
    5
    Views
    456

    Re: Gear swap shop

    In Colorado Springs my recommendation would be Predator 4WD.

    http://www.predator4wd.com/
  17. Replies
    3
    Views
    160

    Re: Silver Surfer Jeep LJ

    Amazing...
  18. Thread: Confused

    by Brian
    Replies
    9
    Views
    352

    Re: Confused

    Looks like he's just waiting for the lift and winch to show up :lmao:
  19. Replies
    10
    Views
    521

    Re: Newbie from Highlands Ranch

    Hey hey!
  20. Thread: OCD organization

    by Brian
    Replies
    5
    Views
    243

    Re: OCD organization

    I have the same ones. Got them here:

    https://www.bartact.com/
  21. Thread: OCD organization

    by Brian
    Replies
    5
    Views
    243

    Re: OCD organization

    Looks like a clean set up. :thumb:
  22. Replies
    4
    Views
    182

    Re: In case you need an engine hoist....

    They walk among us...
  23. Replies
    121
    Views
    5,763

    Re: Moab Oct 9/10 - 12/13 ?

    It's looking that way for me. I need to wait until next week (best case) to see how a couple work related things shake out before I can say for sure.
  24. Replies
    12
    Views
    301

    Re: Jalopnik - A little love for the LJ

    Rawk on! \m/
  25. Replies
    121
    Views
    5,763

    Re: Moab Oct 9/10 - 12/13 ?

    Thanks for the recommendation! Things are looking promising with work and this place seems like a nice/convenient place to stay. I'm thinking we'd bring the truck camper and just flat tow the Jeep...
Results 1 to 25 of 50
Page 1 of 2 1 2
BACK TO TOP